
June 2021: It was a warm sunny Saturday when Paul from South Coast Customs & Classics arrived to transport the 1302S Beetle back to his workshop. The plan that day was to separate the body from the floor pan as well as strip down the car some more so the welding on the body and replacement of the frame head could commence.


It turned out to be a lot more difficult than expected with the body being welded to the floor pan in a few locations. Each corner on the rear edge of the floors, each side of bulkhead and on each side of the frame head near the body mounting points. Paul had to cold chisel, angle grind and lever the body and floor apart to break the welds off, though some crumbled due to corrosion. After a fair amount of sweat and effort by Paul the body was ready to be lifted off, quite possibly for the first time in it’s life. Looking at the amount of work Paul had put in to separate the body and floor I was glad he was on board to deal with this, I couldn’t have ever managed that.








With the floor pan now exposed it was clear to see the poor state it was in, even the new floors which were put in 1997 were effectively scrap due to being welded to the body. The frame head had already been identified to be replaced and the “napoleon’s hat” floor pan bulkhead was in a poor state.
I’m not sure if Paul was being kind, but he said it wasn’t the worst beetle he had worked on, which kind of reassured me that this wasn’t going to be too difficult for him to tackle.