Categories
bodywork paint painting seals

Engine Bay Paint and Rubber

At the end of summer the weather was still warm and dry, so I took the opportunity to respray the engine bay in bright white, as before, however this time with successful results. With some fiddling I worked out how to get my spray gun to a correct working pressure and I took extra care of getting my paint mixture right. I took my time spraying three thin, wet coats with 4-5 minute pauses between each coat allowing for it to flash off. I took the opportunity to spray the rear wheel arches to clean them up as well and the result was a fresh glossy finish and finally to my satisfaction.

Another milestone achieved was fitting the engine bay seals that I got from Just Kampers. Fitting of the firewall seal was relatively straight forward, not too much prying or effort required and was done in a bout 20 minutes. The other engine bay rubber was more tricky, though made easier because of the removable rear valance and I could do it in three stages. Rubber gloves, the type used for mechanical work with a pair of large pliers were needed for a good firm grip and vaseline to ease and slide the rubber into the channel. It took about 45 mins to complete.