Categories
chit chat

May 2016

Nothing much to see here…

Just look at what I had done and left that engine out on the floor like that since May 2009! It was covered up but it still had 7 years of dampness to spoil it some more. Note the rear end was resting on the gearbox mounting, on an off-cut of an oak gate post, as at some point I needed the substantial car ramps to work on the Corsair [Link Here]. With the help of my growing up and stronger son, we moved the engine into the relatively more shelter of the carport and put it on a pallet. I then wrapped it up some more to protect it from the elements for the unforeseeable future. Also, notice the Capri [Link Here] was still in my possession and would eventually be sold in March 2017, that was a sad day.

Categories
chit chat engine

Dropping the Engine

By May 2009 I had some spare time, money in the bank with the next idea to remove the engine to either strip down or consider a short block replacement. When we bought the car in 1995 we were told of a bottom end knock which was either crankshaft bearings or the big ends needed replacing. With the rear end jacked up and the car on our substantial ramps removal of the engine wasn’t as difficult as I remember, four bolts, bit of a jiggle on to the trolley jack and it was out…

The following month the money set aside for a replacement block was spent on a refurbished gearbox for the daily driver Passat. In hindsight – it was probably just as well because no more was done to the little car for some time.

Categories
bodywork chit chat pedals

Runners and Pedals

The financial situation had eased which helped fire up the enthusiasm with the Beetle in the spring of 2008. The covers were removed to reveal the Beetle was fairing well in the car port under a tarpaulin. At some point, Grey zinc primer had been applied to the surface rust that was appearing on the repairs done in 1998.

A pair of correct style seat runners were purchased as the new floor that had be done 10 years previously had the wrong type. I also bought a new accelerator and clutch cable as well as some foot pedal spare parts. There is not any photo graphic evidence, but I replaced the seat runners by drilling out the spot welds on the existing runners and successfully welding in my new ones. My welding had improved (albeit some what agricultural) since 1996, as I had built this dragster for my then young son for a carnival.

By early summer 2008 and I had the foot pedals with other associated parts powder coated in readiness for installation. The powder coater had unfortunately painted over some areas that needed to be clear of paint and a fair bit of rubbing down was required so it would all fit together and operate smoothly. Installation was tricky but I had to drill holes in the new floor to weld captive nuts on the underside so I could bolt down the mounting bracket for the whole assembly. I welded the accelerator pedal bracket to the floor, it was not pretty but functional. Fitting the clutch cable was nigh on impossible even with guidance in the Beetle bible (How To Keep Your Volkswagen Alive) so I left that for another time.