Categories
bodywork

Preparation begins

By March 2021 I had begun to take a closer look at the areas I thought would require repairs. Armed with an angle grinder and a knotted wire brush attachment, I started in the right hand side rear wheel arch. As I ground away behind the black under seal there was a lot of filler which covered up a multitude of repairs. The body to chassis mounting point was badly corroded and around the wing mounting there was a lot of hidden rust holes – it wasn’t looking very good. More work was required on the left side front inner wing and suspension strut tower. On the right hand side by the brake master cylinder there was body to floor pan welding as well as in the drivers side foot well and on both sides the floor to bulk head bolts had been welded over.

As I worked my way around the car I seem to open up many areas that needed further investigation, all these old repairs and fixes, are probably what saved the car from being an MOT failure in the past and then being scrapped. In the meantime, I had messaged Paul at South Coast Customs & Classics a few times to check on the timeline of when he could take the Beetle in to this workshop but also to invite him to come over and take a closer look at the car. By April (2021) I was becoming rather despondent and wondering if it was really worth continuing as the repair list was getting longer and possibly out of my financial reach.

After Paul’s visit at the end of April, his confidence and enthusiasm to do the repairs to the car was very reassuring and went a long way in securing my decision to continue and go for an all out restoration – though not to any concourse standard. I continued to collect more panels for the repairs prior to when Paul could take the car in to his workshop. The final project list I drew up is shown below (June 2021 Version 3)