After watching a few YouTube videos, I gave spray painting a shot in the engine bay around the end of July 2023. I chose bright white (RAL 9010) and used the hardener/activator that came with the primer. I was careful not to use too much, as I thought the primer and hardener were best kept to work together in their specific proportions.
My first try didn’t go so well. I put on too much paint at once and used too high of an air pressure. This resulted in paint running, dripping, and forming pools in the engine bay. I was able to fix it by sanding down the runs, getting rid of the drips, and smoothing out the pooled paint. This got things ready for my second attempt. I also had to apply some primer again on the areas where I had sanded down to bare metal.





By mid-August, I made a fresh purchase of activator/hardener and acquired 2 litres of VW Clementine (L20D) orange paint, ready for another attempt. The second endeavour of applying the bright white to the engine bay proved more successful. I opted for a previously well-used spray gun this time, made adjustments to lower the air pressure to approximately 3 BAR, and exercised patience with 10-15 minute intervals between each paint coat. The process took several layers to fully conceal the grey primer due to the underlying white colour, but the patience paid off with improved results and fewer instances of runs. Any runs that did appear were effectively addressed using a cloth soaked in thinners.

With my newfound knowledge, the next day for my third try at spraying, I embarked on applying the orange paint to the interior of the Beetle. I concentrated on trying to refine my spray pattern and deliberately took my time to avoid any hasty work. Though a few issues still emerged, such as the presence of an “orange peel” texture, which might have been due to subpar surface preparation or spraying too closely to the panel, leading to a dimpled effect. While I believed I was more cautious about overlaps and repeated spraying in certain areas, it’s likely that my approach to delivering paint was overly generous, resulting in excessive build-up in certain spots, causing runs, drips, and sagging. Overall, witnessing the Beetle’s interior entirely coated in orange provided a tremendous boost in confidence and propelled the project forward.





Following the correction (more sanding back with 320 grit paper) of drips, runs, and the orange peel texture, 72 hours later, I gave it another shot. This time, I invested in a new spray gun equipped with a slightly smaller needle (1.4) and more refined controls. The experience of spraying felt smoother and more controlled due to the enhanced air pressure and paint volume regulation. However, the orange peel effect persisted, and it might have even been more pronounced than before. Fortunately, I didn’t encounter any runs or drips. The challenge seemed to lie in the paint’s atomisation or “dryness” upon exiting the gun, hindering the desired smooth gloss finish. This issue could have arisen from incorrect mix ratios of paint, hardener, and thinners, or potentially from a restricted paint flow caused by the inline paint filter in the gun, which at least prevented runs from occurring. And one more final problem, overspray had got in to the engine bay and I had a fine tint of orange on the white.
Blog post words assisted by ChatGPT





48 hours later I took a closer look at the small components that I had sprayed which also had the orange peel effect. I used 800 followed by 2500 grit, wet and dry paper to remove the textured finish. Then polished with T-cut a couple of times. The result was OK more of subdued shine but not the deep shine I was hoping for – perhaps a higher grade cutting compound was needed rather than just the T-cut.



It will be back to flattening off the orange peel effect on all surfaces that will be on show like the dash and door shuts, including the small parts sprayed separately and trying again to lay a smoother paint finish at a later date.
One reply on “Painting 2K”
[…] was still warm and dry, so I took the opportunity to respray the engine bay in bright white, as before, however this time with successful results. With some fiddling I worked out how to get my spray gun […]