Categories
bodywork paint painting

Body Work and Paint

Painting back in May (2025) with colour was another failure.
As I mentioned in my last blog, it was actually worse than my first attempt. A severely clogged spray gun, full of old paint, combined with blocked vents on the paint cup, only added to the list of faults with my cheap 1.5-nozzle gun. The replacement 1.4 Fast Mover FMT 3006/1.4 hadn’t fared much better either, thanks to a poor clean after the earlier primer disaster.

VW 1302S Beetle body in pre-paint prep stage
VW 1302S Beetle body in pre-paint prep stage

After feeling pretty despondent with my painting results, I phoned Advanced Paints and spoke to Luke for some advice. Once I told him the expiry date on my Spectral Under 355 primer was more than a year out of date, he confirmed it had very likely gone off. The Clementine L20D orange I’d bought from them was also due to expire this year, but he reckoned I could probably still get away with it. He recommended a replacement primer and hardener (Kapci) and suggested using a 1.8-nozzle spray gun. With that purchase, I now own the full set of Fast Mover 3006 spray guns — 1.3, 1.4, and 1.8.

So, it was back to basics once again. I rubbed back all the poorly applied orange paint, through to the primer and, in several spots, right back to bare metal. This also gave me the chance to deal with a few filler touch-ups — the rear right quarter panel, the front valance (again), and some smaller imperfections. Using the new Kapci primer with the 1.8-nozzle gun gave me far better results than before.

A week later, I cautiously approached the next step — adding colour. I made a deal with myself: if the test spray didn’t come out evenly, I’d ditch the mix and walk away. I mixed the colour and hardener 2:1, adding 10% thinners to make sure it wasn’t too viscous, especially as I was using a fast hardener with a quick drying time.

The test piece looked OK — better than my first attempt — so I pressed on. This time I put down thinner coats with about five minutes between applications. After around three hours, the paint was touch-dry. It’s maybe just good enough to live with… and it’s given me the confidence to use up the rest of the L20D Clementine orange on less visible areas, such as the bonnet shut lines and other hidden sections.

What’s next? Well, assuming my optimism doesn’t fade as quickly as the last paint job, I’ll be working my way around the Beetle panel by panel, saving the trickiest bits for last. That way, by the time I get to the most visible sections, I’ll either be a seasoned pro with the spray gun… or I’ll be phoning Luke again for yet another pep talk.

Original draft text re-worded by ChatGPT

Leave a Reply

Your email address will not be published. Required fields are marked *