Categories
steering suspension

Gearbox goes away & front strut reassembly


At the end of January, I took myself on a road trip to Newcastle-under-Lyme to visit John Walklett Transmissions. I could have sent the gearbox via courier, but for the cost involved, I may as well go myself—and this way, I could speak to John face-to-face.

His workshop was a small unit packed to the rafters with VW air-cooled gearboxes and crates of spare parts. We discussed the options for our “AH” code ‘box and settled on a freeway flyer setup with a taller 4th gear, allowing for lower revs at cruising speeds (60–70 mph). Seeing John in action was well worth the trip, giving me confidence in his expertise and a sense that I was a serious customer. I gave him a no-rush deadline but mentioned it would be nice to have the gearbox back before September—he assured me he’d be worried if he still had it by then!

Over the Christmas break, I dug out the front strut components to clean them up and fit new lower ball joint rubber boots. However, the replacements I’d bought some time ago turned out to be too small. I suspect I was guessing the size when I originally ordered them, and I got it wrong.

So, in January, I ordered the correct ball joint boots, along with new CV joints to replace last year’s attempted rebuilds, plus a few extra parts to complete the front strut refurb. Over an afternoon and a few evenings I reassembled the front struts with new brake disks, inner & outer wheel bearings, strut inserts, bump stops and the -2″ lowered springs bought way back in the late 1990’s when the wife and I started out on the restoration journey.

Other parts that received reassembly were new rubber boots added to the steering tie rod ball joints. The gallery below shows that the vice came in very handy as an extra pair of hands while two small screw drivers were used to ease the blue springy clips in to place to secure the boots. Fitting the ball joints to the tie rods was not easy as the threads were quite contaminated from the sand blasting and powder coating process and took quite a of ‘cutting in’ by winding them in and out.

Leave a Reply

Your email address will not be published. Required fields are marked *