I got the Corsair back from John’s in mid July after he restored the nearside jacking point and the floor chassis sections in front of the rear spring hangers on both sides. He had also cut out previous repairs on the rear chassis sections under the rear seat and restored to like new. When I collected the car, John informed me the side lights and a head light were not working, but when I tested them on my way home all seemed to be working.

I tried the lights another day and they didn’t work, even one headlamp was out. Armed with my multi-meter, I started with the light switch by testing for a current on all the terminals which appeared to be OK, but still no lights. I contacted a friend to come over and help who chased about the faults while also trying to fix the broken indicator bulb wire. It was while I was waiting for the friend to come over, I decided to change my temp gauge and fuel gauge dash dials (presents from Christmas 2018) and in the process one of the indicator wires broke away from its bulb holder.
With a lot of fiddling about the sidelight circuit was working again but seemed only after using the indicator. The other issue of the indicator dash bulb was eventually fixed by ordering a new bulb holder from AES Auto Electric Supplies that had a spade connector to make life easier for connecting the loose wires that also required a new female connector to be added. New 7″ sealed beam head lamps were ordered from H Bower (on Ebay) as my units output were a bit dull and one wasn’t giving back consistent readings on the multi-meter.

So a few days later I gave the Corsair a run out and again to test the lighting circuit but after a fair amount of switching lights on and off and indicators on and off, the side light circuit worked. But I turned the lights off when I neared home so I could test them again when parking up in the garage and… the lights didn’t come on.
On aother day, I was back to testing and was advised to test only the switch this time off the car. Using my multi-meter (with virtual guidance via email from a friend) I tested the Ohm resistance as well as using the continuity test (passing electrical current through) from power in to the side light circuit terminal and there was no readings or any sounds from the continuity circuit. The Main light circuit terminal had readings and sound from the continuity test. When I tested the side light circuit with the main light switch in the on position I was getting intermittent readings and a broken sound when I connected via the side light circuit terminal. With the info passed on to the friend and with my own thoughts that would explain the fault of no side lights.
I ordered a new switch from Car Builder Solutions and went for a black lever toggle switch and also added a new dash light (on/off) switch and heater switch to match things up on the switch panels. The switches arrived within 4 days of ordering and felt nice, being a combination of metal and plastic, having a proper ‘click’ when the toggle lever was moved. The switch (off/On A/On A+B) was tested and the lighting circuit worked. I replaced the on/off dash light switch and the heater switch (on/off/on) so they all matched.
The Corsair was submitted for an MOT this time with a garage I had been using for many years (Ian W Hull Car Maintenance) and it passed with only the advisory on the exhaust blowing in three places. This was the third consecutive time the car had to attend it’s MOT in the rain.




