The carburettor was fitted a couple of weeks ago (18 Sept 16) along with the radiator and cooling system for a test start up. However, it didn’t work out as well as I hoped. While the car started easily the carburettor was not set up right or properly adjusted or whatever… With the choke out the engine was revving high – guessing 2-3000 rpm and with the choke pushed in it rose higher still! Fiddling about with the volume control screw didn’t seem to have an effect, even swapping it out for another only made things worse. I had to abort the running engine when the revs were rising – and so it was back to rethinking what was wrong.
A couple more weeks pondering options, re-reading paperwork and on-line solutions gave a hint that the carb needed rebuilding or stripping down again.

Back in the garage, armed with a better mood I tried again with the carburettor rebuild, took it apart and sought to clean the mating surfaces within it more efficiently. Using 1200 grit wet/dry paper lubricated with WD40 I rubbed down the surfaces again though a bit more thoroughly and getting a cleaner/shine to them. While it was all apart I sprayed more carb cleaner in various orifices when removing a variety of screws.

Upon rebuilding I paid more attention to the set up of the throttle stop and volume mixture screws and then put it back on the engine. I tentatively restarted the car without any choke to begin with and it fired up ok though was a bit lumpy. I gave it a small amount of choke and it ran fairly smoothly but not at high revs this time. Blipping the accelerator was smooth and there weren’t any pops and back fires through the carburettor. Idling needs to be adjusted properly with a tweak to volume control and throttle stop required, but that can come on a later date.
So far so good, I had a minor leak on the brake system while the car was away being restored, so that will need re-bleeding all round.
