New Shocks and the MOT

Finally in to the new year and there was a nice day (Sunday) to get on and fit the rear shock absorbers I had bought at the end of last year. Initially, I had a drive locally in the Corsair, not too far due to lockdown restrictions but enough to blow the cobwebs out and get get some warm air blowing through the car.

Fitting the shocks wasn’t a difficult job as I had read up on it before starting and it didn’t necessitate in too much preparation. I had applied plenty of WD40 to help free off the lower 3/4 inch bolts which didn’t turn out to be a chore. Neither were the top mounts of the dampers, in the boot, but they were awkward to reach and required mole grips as well as the 9/16 spanner to loosen and undo. The old (Monroe) shocks came out easily and I had no idea if they were in poor condition or not so have been kept as spares.

Fitting the rear shocks was a little more awkward and I soon discovered that fitting the top mounts in place first was easier than fitting the bottom mount. When I did it that way first, I had to push the shock absorber up to the mount hole and then try and get the rubber, washer and bolts on before the mount would disappear through the mounting hole!

With the bolts all tightened up and a quick test drive I was happy another job could be ticked off the list and the car was ready for its MOT.

Well, the Corsair failed the MOT with the steering box classed as dangerous and two areas on the rear spring hangers needing welding. The exhaust joints require separating and resealing and there were advisories on a jacking point and the prop shaft rear joint showings signs of wear. So, not a great day and a few issues to sort and while in lockdown may not be done particularly quickly.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.