Back in May I left the convertible roof hood frame with John Midwood with a simple brief to re-weld a broken bracket and weld in a metal stop for the hood tensioner handle, that had been missing or broken in all the time I have owned the car. At the end of June I popped over to John’s for a cup of tea, chat and to collect the frame.


The frame was looking rather scruffy and rusty with some mis-matched bolts and flaking hand painted silver hammerite. So I bit the bullet and decided to dismantle the whole mechanism and refurbish it. I ordered a bunch of stainless bolts, washers & nuts (1/4″ UNF), dome nuts with washers (7/16″ UNF) and I also ordered countersunk hex head bolts (1/4″ UNF) but they were too short to be of use. I used Westfield Fastners because they have an easy to use website with a massive range of finishes, sizes and can supply to the general public in small volumes.







For reference, I took several photos before disassembly but with hindsight, I would have laid the frame out on a table/bench rather take pictures of it upside down clamped in a vice, so as to have made reasssembly easier to follow. There were a couple of stubborn bolts that sheered but it all came apart fairly simply. With all the frame in bits, the next step was to use a polycarbide paint removal disk on the angle grinder to take off the flaky paint and surface rust. The polycarbide removes the paint and rust well and leaves a clean metal finish without heat tarnishing that a wire wheel can do. I had to resort to the knotted wire wheel when the polycarbide disk wore down when it wasn’t getting in the corners so well.
I had some left over smooth Hammerite aerosol paint from the exhaust rear box job, so this was just the stuff to apply to the frame. Coverage was good and clean but I did miss a bit of coverage on some of the smaller components. Reassembly ended up taking more time than expected and I had mis-counted the nuts and bolts I needed, so had to refurbish 4 of the best bolts, nuts & washers for re-use. The pictures show a much improved look and for most of the the time the frame will be covered up anyway.




