Carburettor rebuild (Zenith 361V)

While the Corsair was away at AJ Restorations I had a go at rebuilding the Zenith 361V carburettor. I had bought another one to practice on first, but it was mainly designed for a Land Rover application as the fuel inlet was different and I wasn’t sure on some of the other internal subtle differences, so it was not suitable for the Corsair application. The only part I salvaged was the rod connecting the floats as the original was bent. I refrained from swapping the pump too as the Land Rover one had a much softer spring and I wondered if that would have an adverse effect on final operation.

The images are in a sequential order and partially explain the process.

Plenty of time was spent taking it apart and with the old gasket scrapped off and the whole carb dismantled, the mating faces of the body were rubbed on 1200 grit wet and dry paper with WD40 as a lubricant to flatten the surfaces. Plenty of carb cleaner was sprayed in all the holes and orifices then blown through with an air duster but it wasn’t very powerful.

I used these useful links to help in my research for what to do:

At this point the carburettor is untested but no doubt a report will be done once it has been fitted. I hope that was of interest and thanks for viewing.

2 Replies to “Carburettor rebuild (Zenith 361V)”

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.