Had about 2.5 hours out in the garage fiddling about with the Corsair – got the new alternator fitted OK this time and looked at changing over the dodgy ignition barrel – but I bought the wrong one that had 3 main terminals not 5… So liberal amounts of lube oil and WD40 into the old one (it was sticking on starter turn over) and cleaned up the terminals and then it took a few attempts working out which wires plugged into the terminals – I tell you, I don’t do things very well in my haste and forget to make notes before taking apart or unplugging…

When I connected the battery the car turned over – so I had some wires mixed up! Couldn’t really understand the wire diagrams in the Haynes manual but swapped a couple around and all seemed fine – Also the ignition light on the dashboard went off when the engine was running so I presume the alternator conversion worked and the battery was getting a charge.
Engine ran for a bit, only enough to get it back into the garage before it died. Also I need to re-fit the fuel return, as it squirted out fuel (from the carb) on an earlier start up. Odd thing is I never disconnected a fuel return pipe in all the time I’ve had the car and thought it was a redundant left over from when the electric fuel pump was added – anyway, the return pipe that I took off the other month, luckily I kept it so it will be going back on.
I fitted the rear wheels too, however, I was a bit concerned that one of the washers was being pulled into the wheel lug hole by the new wheel nuts I bought. It could be the shaft diameter of the wheel nut could be too narrow for the wheel lug hole – so more expense likely getting the right nuts.
