I took a closer look at the brake discs to see what could be done with them. They had a lot of surface rust from nearly 14 years of being idle, however I had seen on a forum and then a Youtube video about cleaning rusty brake discs with a poly-carbide disc. Unfortunately I couldn’t get hold of a disc for my angle grinder but the got one for the electric drill instead, which was OK, but I think the angle grinder version would have done a better job, so will re-order another from Amazon. The front face was quite heavily pitted after the clean up and wipe down with clutch/bake cleaning fluid. The back face wasn’t too bad, but I am hoping the brake pads will bed them in more as they get used.



I didn’t get much further as I had a passing visitor and was happy to chat about the Corsair, so I only got the nearside cleaned up and back together so I didn’t take any more photos. It all came apart easily enough and I may remove the brake disc again next time for another go and the brake master cylinder will need to come off as it appears to be seized again. Also, I am getting used to reconnecting the battery each time and starting up the Corsair to drive back into the garage – so much easier now rather than pushing it back in!
Easter is looming so I hope to have a day or two on the car to finish the front brakes and another attempt at removal of that pesky rear flexible brake pipe, so I can put in my new stainless pipe.
As a side note, I obtained new M16 calliper fixing tabs from Burton Power, I chanced the metric version and the bolts fitted through them fine to secure my imperial P16 callipers. So the way I see it, M16 and P16 callipers are the same dimensions but have metric (M16) or imperial (P16) bleed nipple and fluid line threads.
