After the trip to the British Motor Museum, at Gaydon, the Corsair was running a bit rough, so a bit of a fettle with the points gap and it ran nicely on a mid week local run about on a cool sunny evening. Come the following Sunday, I had planned to see a friend but the car ran lumpy under load and was basically undriveable, so the trip out was cancelled until I could fix the problem. One thing to note, I refuelled the car to the top again after the Gaydon trip (200+ miles) and estimated the fuel economy to be about 30mpg.
To source the ignition problem and armed with my multimeter, I tested all the plugs, HT circuit, condenser, points gaps and then the coil. The coil was pushing out poor readings on the primary circuit at less than 1 ohm (non ballasted system should be 3 ohms). So I tested an old spare coil and the ohm readings were far better. Once the old coil was put on all the running issues were cured (for now).


Several local drives along Wiltshire country lanes were enjoyed (see the video of Tisbury) and a trip to my place of work on a warm day in early June. All was good on the journey to and from work, however, on the way home there was more of a whirring noise from the engine bay. I was thinking it was the alternator pulley, for some reason, as I had been hearing it on and off for some time, perhaps around the time I converted the car to an alternator a few years ago. An inspection later revealed a very wobbly water pump pulley. I ordered a new water pump (without the back plate) from Burtons and received it in time for the weekend.
As I would be working on the car to fit the water pump I also decided to do an oil change and the oil I already had was more than enough but I had to re-use the oil filter as the replacement, I bought a while ago, was the wrong fitment. The water pump wasn’t particularly difficult to do, just a bit messy. The new pump came with two gaskets, one to seal to the back plate and then seal the pump assembly to the engine block. Within 2.5 hours all was done and upon firing up the car to test for leaks the engine was a lot quieter. A proper test drive the next day and I couldn’t believe how quiet the car was, just highlighting the fact that the blowing manifold joins needing a bit more fettling to seal better. I took the car again to work (round trip of 50+ miles) and it was a great run, not to hear those engine noises.





