Exhausting exhausts

Way back in December 2021 I bought a couple of exhaust manifolds on eBay with the intention of fitting them over the Christmas holiday. Three months later I finally get around to finding the energy to do something about them. With the car turned around in the garage and supported on axel stands I begun to undo the exhaust clamps and manifold bolts. I knew I had a bent manifold bolt to deal with and used my Christmas money to purchase a Dremel drill. Thankfully I chose a Dremel 4000 (175W) kit to cut off the bolt that a socket or spanner could no longer get a purchase on. It was just as well I had gone for the kit with the flexi extension, as the Dremel would not have got in to the tight space under the manifold to cut the bolt head off. The job of removing the manifolds had taken about 1.5 hours as the down pipe clamps to the exhaust system were tricky to reach from under the car. As can be seen in the picture (below) they were in a poor state and the gaskets had crumbled away to nothing hence the severe blowing experienced.

Ford Corsair exhaust manifolds
Ford Corsair exhaust manifolds that were removed
Ford Corsair & exhaust manifolds
Corsair (V4) in the garage with it’s exhaust manifolds removed

With my Dremel, I cleaned up the exhaust clamps and sealing rings and removed crusty corrosion and exhaust paste residue. A few days later, fitting the new studs and bolting on the good, second hand manifolds was the easy bit. Getting back underneath the car with restricted space to move my arms, fitting of the manifold down pipes to the exhaust system clamps was very awkward and difficult. Using a jack to hold up the exhaust system helped a lot but I still needed shorter forearms and triple jointed wrists to get a good position to use my ratchet easily.

After fitting and re-attaching the alternator, plug leads and air filter the car was ready for a test run. There was slight blowing from one of the joins at the manifold down pipes but not blowing like it was. A week later I took the Corsair on a proper run to see a friend and it covered a good 50 miles in the afternoon of joy riding around the Warminster area.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.